KJW Beretta M92 Slide

[eV.Viper]

Hi,

I've disamantle my slide to fix a problem, but i've created a new one!
I'll refer to this link for the part numbers: http://www.pegatiros.com/download/de...skj/kj-m9s.jpg

The little parts for the safety trigger (#28 & #29) seems to go nowhere in my slide! I'd like to know if someone knows where these parts go. If you have any picture it could help, because on this diagram i can't figure how the pieces go.

Thank you

[Konig]

Hi,

I just had a look at my KJW M9, as far as I can see parts # 28 and 29 don't actually go in the slide itself. There should be a little hole in the safety switch (#26), first install the spring (#28) then the plastic pin (#29). I would think you would need to hold the plastic pin so that it won't fall out with your fingers, then install this half of the safety switch (#26, 28, 29) through the slide (#1) while still holding in the pin (#29). Then attach (#27) using the set screw (#25) to the other end of the safety switch. I hope I've helped you. If you have any questions just ask.

Merry Christmas.

[eV.Viper]

Thank you for your help, it helped me a lot!

Merry christmas you too and thank you again