GATE TITAN Mosfet problem

[Proliphic]

I just installed a gate Titan mosfet in my G & P Defender and for some reason it won't fire..

I tested the motor so I know it works all the Titan sensors read trigger position selector switch position and on the top board of the Titan there is a red fast blinking LED..

I have checked everywhere I can think of to find out why it won't spin the motor I have the gearbox strip down so that the only thing installed is the mosfet, trigger and motor .

Can anyone shed some light on this?

BTW it's running off an 11.1 lipo

Sent from my SM-G930W8 using Tapatalk

[rking]

Have you installed the sticker onto your selector plate properly? and also put it into the body fully assembled, the titan uses light sensors, it wont function properly out of the body of the aeg.

[Proliphic]

Yes I have installed the selector plate sticker and in sensor mode it reads the trigger pulls and fire mode selector switch fine.

. it seems to be always throwing the code E05.
which when i look it up it comes up as "Amplifier Error" ?!? not sure if this is just a lemon of a unit or something on my end..

[Proliphic]

Well just to update on the situation I sent an error report to Gate support and It seems like it was a defective bottom board. So Gate is honouring the warranty with no questions asked.

But being impatient and needing the gun working that sunday to game with, I bought a replacement TITAN and installed it and it is working phenomenally!

**Just for an idea of timeframe**
I emailed them on the evening of good friday and they had gotten back to me and approved the warranty by Tuesday morn at 10am EST.

So far I'm impressed with their warranty program.

Cheers
Proliphic

Sent from my SM-G930W8 using Tapatalk

[devbro]

Next time, use the USB or card for testing sensors

[Proliphic]

Next time read the posts...

The sensors were all showing that they were working as stated in my second post.

Sent from my SM-G930W8 using Tapatalk