co2 pistol mag seal.

[Hectic]

Anyone know where to get the little while seal/gasket that goes in the peircer area of co2 pistol mag? Namely the les baer custom 1911, prety sure its OEM by KJW sold under the socom gear brand.

[voorhees -FWA-]

An easy fix for this, instead of changing gaskets, is to Teflon tape the top of the Co2 cartridge and install as usual.

If that's not your jam, you can take it all apart and give the gasket a silicone bath for a few hours. Let it soak, wipe it dry and reinstall. In most cases, doing so will revitalize the gasket and seal to your cartridge again.

[Hectic]

That would work if i had the gasket lol.
not sure how or where but within 2 co2 carts the gasket was lost

[voorhees -FWA-]

Ah, that's shitty.

If you have any Co2 guns that are broken or that you don't use anymore, the gasket should be able to be swapped out from it. My understanding is that since the powerlet is universal, per se, then the gasket for the piercer should be too.

The gasket is held in place with a grub screw and can be removed with a large flat screw driver, remove the gasket and the piercer and a small screen will fall out.

I'm not sure if there is a place where you can buy just the replacement gasket but I will check with a couple guys I know and will post back if I do find anything.

[Hectic]

Sweet thanks. Im thinkin maybe a paintball shop, just havent been by one yet lol