Make some small ball bearings with a soldering iron

[GeckoP]

Did you lose those damn small ball bearings that are under your selector plate or on those hop ups?

Well here is a easy way to make some quick replacements for those little suckers

Step 1

Plug in Soldering Iron

Step 2

Melt some solder on the tip

Step 3

Flick the iron so the solder drops on a flat table.

Step 4

Enjoy your small bearings.

If you are replacing a hop up ball bearing, you may have to find just the right size or it will be either too much hop or too little.

I found out how to do this completely by accident and thought I should share.