Holster For Upgraded TM G17

[redneck12]

I just purchased a TM G17 and a Guarder slide, I am looking for a holster preferably a BH Serpa. Will this set up fit in a G17 Serpa or do I need to up size.
Thanks for any info.

[Stealth]

I don't see how a simple metal slide replacement would instantly make a holster not work.

However I should point out that TM frames are out of spec from real-steel Glocks.

[Spike]

China knockoff serpas fit TM glocks wonderfully. I got mine off ebay "thebjshop"

[redneck12]

I have a ACM knock off Serpa and my "G17" paintball pistol fit in it no problems but the TM won't, even with the new slide on it. I was just wondering if there was a Serpa it would fit in before I bust out the sand paper and take alittle material out of the holster.

[ratnest]

israeli-weapons.com, lot of different holsters that work with glocks, also good mag pouches/hard to find bits

[L473ncy]

You have to sand down a little bit inside your holster, just a little bit to make it fit better. TM frames are ever so slightly larger than real steel Glocks (see my review of the Cansoft TM Glock, note that this is common among all TM Glocks even the "black" ones).

If you do decide to dremel or sand it down, remember to do it slowly. Taking material off is easy, if you take too much off you can't easily replace it.

[Shirley]

My real Serpa will fit my TM G18 with PGC slide. The new PGC slides fit RS holsters.

[redneck12]

Ok thanks for the help time to bust out the sand paper.

[Invasian]

NO NEED FOR SANDPAPER DUDE...

I run a TM Glock 17 with metal slide with my RS Blackhawk Serpa for a Glock 21/22. It fits perfectly

The TM Glock is slightly thicker than its RS counterpart....