getting prepped 4 TTACCC (toronto)

[5udhir]

hello, i have a few questions about getting my aftermath tm clone mp5j ready for gaming at TTACCC.

-Since the max fps allowed is 350(according to website) what ype of spring should i get to keep me around 300-310? Please keep in mind that i want to install a new piston head(sorbo-pad type from airsoftpart.ca) and a tightbore barrel.
-Could somebody also recommend a tight-bore? the length of the mp5j barrel is 229mm.
-Another thing i want to upgrade is the gears, i want a torque-up gearset(helical) because i read that helical gears are more silent. will this give me a higher rof?(even though full auto is not allowedat TTACCC)
-Also a recommendation of a battery voltage and mah rating would help(the one it came with is 8.4v,1100mah)

I still have more questions

-How do I go about completing the first level of training/classes at TTACCC? Is there a fee? I understand you need this to play at TTACCC.

-What are the mag capacity limits for mp5's there? I have a 50round mag, but I read that only 30round mags are allowed. But somebody also told me that they do not make 30round mags for mp5s.

I guess thats it for now, thanks in advance for your help.

[Bowers]

Originally Posted by 5udhir

hello, i have a few questions about getting my aftermath tm clone mp5j ready for gaming at TTACCC.

-Since the max fps allowed is 350(according to website) what ype of spring should i get to keep me around 300-310? Please keep in mind that i want to install a new piston head(sorbo-pad type from airsoftpart.ca) and a tightbore barrel.
-Could somebody also recommend a tight-bore? the length of the mp5j barrel is 229mm.
-Another thing i want to upgrade is the gears, i want a torque-up gearset(helical) because i read that helical gears are more silent. will this give me a higher rof?(even though full auto is not allowedat TTACCC)
-Also a recommendation of a battery voltage and mah rating would help(the one it came with is 8.4v,1100mah)

I still have more questions

-How do I go about completing the first level of training/classes at TTACCC? Is there a fee? I understand you need this to play at TTACCC.

-What are the mag capacity limits for mp5's there? I have a 50round mag, but I read that only 30round mags are allowed. But somebody also told me that they do not make 30round mags for mp5s.

I guess thats it for now, thanks in advance for your help.

http://www.redwolfairsoft.com/redwol...l?prodID=16354
30 round mags

[5udhir]

Originally Posted by TCSF-Bowers

http://www.redwolfairsoft.com/redwol...l?prodID=16354
30 round mags

"out of stock"
lol, j/k
thanks

what about the rest?

[Colin_S]

Originally Posted by 5udhir

hello, i have a few questions about getting my aftermath tm clone mp5j ready for gaming at TTACCC.

-Since the max fps allowed is 350(according to website) what ype of spring should i get to keep me around 300-310? Please keep in mind that i want to install a new piston head(sorbo-pad type from airsoftpart.ca) and a tightbore barrel.
-Could somebody also recommend a tight-bore? the length of the mp5j barrel is 229mm.
-Another thing i want to upgrade is the gears, i want a torque-up gearset(helical) because i read that helical gears are more silent. will this give me a higher rof?(even though full auto is not allowedat TTACCC)
-Also a recommendation of a battery voltage and mah rating would help(the one it came with is 8.4v,1100mah)

I still have more questions

-How do I go about completing the first level of training/classes at TTACCC? Is there a fee? I understand you need this to play at TTACCC.

-What are the mag capacity limits for mp5's there? I have a 50round mag, but I read that only 30round mags are allowed. But somebody also told me that they do not make 30round mags for mp5s.

I guess thats it for now, thanks in advance for your help.

1. What MP5J do you have right now a TM? If so that should be shooting at ~280 fps, a tightbore, new piston head and perhaps a ball bearing spring guide should put you up into the 300 fps range

If it's a JG, you're probably shooting past 350 fps, the last few I've worked on have been shooting at 370-390 fps.

2. As for a tightbore, the new Madbull barrels aren't bad and quite economical too. I like Systema/Prometheus but they're a bit more expensive.

3. Helical gears are quieter yes but require you shim the gears well (which may be difficult for a novice). No gears or any dampening you try to do to your MP5 will make it quiet please keep that in mind. Torque up gears are not necessary for low fps springs, only beneficial when you're pushing a higher fps spring. They also lower ROF compared to standard ratio, high speed gears increase ROF but they should only be used with medium strength springs.

4. If you put your battery in the hand guard (in the front) you're limited to minis and the maximum capacity of 1500-1600mAh. Depending on your foregrip you might be limited to 8.4V batteries, I know my CA flashlight foregrip does not let me use 9.6V batteries because there's not enough space.

5. Classes are not required to play at TTAC3.

6. As you now know they do make 30 round mags for MP5s but just load your mags to say 33-34 rounds and you're set. I use low cap mags myself and just load them to real capacity.

[5udhir]

it's an "Aftermath Lycaon" which is the same as a cyma 027. it is tm compatable minus the hop-up

any spring recomendations?

[Colin_S]

http://www.airsoftparts.ca/store2/in...roducts_id=884 that should get you in and around the fps range that you're looking for.

My CA MP5 is using the same spring albeit with a few more upgrades and it's shooting around 340.

[ShelledPants]

On a side note: You don't need anything but a fully sealed set of goggles to play at TAC, there are rental guns available, so just show up. Brian can also age verify you.

[ShelledPants]

Originally Posted by m102404

Good footwear (running shoes that aren't held together with tape is the minimum) is essential.

I think this one was aimed at Jeremy. :|

[Shirley]

Well if you are over the age of 18, you can play and get yourself age verified at the same time which is a great thing. Come out with your Mp5, there will be a chrony, if it is shooting too hot, you can get yourself a rental gun to play while you're there. I've hear the cyma 027 shoots 330FPS..

[Brian McIlmoyle]

I guess I'm redundant now...

Information about the Intro course.

I run a course called "Introduction to Airsoft" Airsoft Technical
Qualification 1 ( ATQ1 )

If you have 0 experience with airsoft.. or firearms or even paintball for that matter its a good idea to sign up for this course . It iwll give you all the information you need to get a head start in the community.

topics include.

1. Safety rules
2.game rules
3.gun types
4.equipment and gear selection
5. looking after your guns
6. Basics of Shooting.

There is an ATQ1 winter session open for sign up now, Ill bump it so interested people can sign up .

[5udhir]

thanks for the info you guys. i'm glad to see toronto has a good group of airsofters.

another thing
would a twist barrel do any good? i read it is good for 300fps-330fps.