|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
September 24th, 2008, 22:15 | #1 |
a.k.a. Bloodlust
|
KJW P226 cylinder return spring
On the picture in the link there are two springs. The longer of the two is the one I'm having trouble with. If someone could tell me where it goes and how it goes there I would be very greatful!!!
It fell out when I was changing the loading muzzle and I didn't see how or where it went in. Thanks in advance! |
September 25th, 2008, 00:08 | #2 |
__________________
"The Bird of Hermes is My Name, Eating My Wings to Make Me Tame." |
|
September 25th, 2008, 00:19 | #3 |
Tys
|
If you are holding the blow back unit, nozzle installed and facing you, the long spring and "rod" goes in, between the nozzle and the metal blow back unit, in the bottom right area. It just sits there. The spring pushes against a tab on the back of the nozzle and the rod faces forward.
When you place the blow back unit into the slide, the rod will be sticking out a bit. Hold it in (doesn't take much) as you push the blow back unit down into place. The slide will hold the rod in place. Now the nozzle should be "springy" and snap back if you pull it out a bit. Best of luck. |
September 25th, 2008, 01:24 | #4 |
a.k.a. Bloodlust
|
Hey, just figured it out. F#%k I'm dense sometimes. Thanks for the help.
BANANA Delete |
|
Bookmarks |
|
|