|
AGM MP001?
I just order a AGM MP001B from Gunner's Airsoft, before I order my rifle I read many post over the Internet that there are problems with a part breaking, causing the bolt to fly foward when It's pulled back. The rifle for the most part will no longer shoot when this happens.
Correct me If I'm wrong but this problem with the AGM MP001 bolt flying foward after you pull the bolt back Is caused by the cheap triger and/or piston sear (Haven't got my MP001B from Gunner Airsoft yet and I dont know anything about bolt actions, so I dont know If the Triger and Piston sear are one In the same, or two different parts) made out of cheap pot metal, breaking.
Anyways, from what I've read on the Internet, the triger and/or piston sear can be replaced with VSR-10 and also PSS 10 triger and piston sears, Is this correct?.
Now If this Is true, would I be better off If I were to just replace the trigger and/or piston sear with one for the VSR-10 or PSS 10 before It even breaks?, and If so, which one do get and replace now or when It does break?.
Like I said, I dont know much about bolt actions, airsoft sniping Is new to me and I'm trying to learn as much as I can before my new rifle gets here. However, If replacing the triger and/or piston sear Is not a long term fix to this problem and the rifle Is just going to break later on down the road after the fix, I'm not going worry about It. I planned on buying this rifle to get me by untill I make up mind as too what rifle and upgrades I really would like to get, should I like airsoft sniping.
__________________
The Only Easy Day Was Yesterday
Last edited by Special Ops; December 3rd, 2007 at 23:05..
|
December 3rd, 2007, 23:00
