|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
July 16th, 2007, 17:34
|
#1 |
|
New switch assembly doesnt fit..
I got my new switch assembly today, and it doesnt fit very well. if i close it all the way, the trigger part doesn't return, and it stays in the firing position. i cant figure out which part is being compressed.. any ideas?
|
|
|
|
July 16th, 2007, 17:35
|
#2 |
|
GBB Whisperer
|
Are you putting it in a Guarder gearbox?
|
|
|
|
|
July 16th, 2007, 18:16
|
#3 |
|
|
no
 its the stock metal be gearbox. the hopup is made by src
|
|
|
|
|
July 16th, 2007, 18:21
|
#4 |
|
GBB Whisperer
|
I actually had this same problem fitting an SRC switch assembly in to a Guarder gearbox. On the half of the gearbox that closes down on everything, there's a nub of metal that sticks out to press down against the switch assembly. I had to grind that down by about 2 mm to get the switch to work right.
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
