help

[fishbone]

i need some help i cant seem to get the pin out of my g&p m4a1 carbine i need to check fuse any one got any ideas how to get it out ploease help me i wanna go play lol

[Renegade)]

umm, the pin? lol, if this is for real, your fuse should be where you house the battery, in the foregrip or full stock, not in the mechbox lmao..

[fishbone]

sorry not to good with new airsoft talk gimme a break lol pulled apart butt where bat is and no fuse took apart most of it and still cant find it i havent even used it yet

[Nik12]

If your battery is in the stock, then wen you take it out, tug a bit on the gun's connector. I'm not savvy to the G&P variety, but if it's like most other AEGs, the fuse is connected up to one of those wires just a little bit further along in the the stock a bit.

[fishbone]

i took the strock apart up till the handle and no fuse

[swatt13]

if its an m16, it will ONLY be on the rear o fthe gun. if youve removed the stock bolt and removed the stock you should have just the wires off the end of you gun under the buffer tube. along those wires (if the gun is new/stock) there will be afuse houseing along the red wire. if not, you dont have a fuse and it now is aeither a connection problem. chech your pins in in the connectoins havent become dislodged. if theyre good, then its battery problem, if your battery is fine, then it could be a motor connection problem.

if its an m4 the fuse will ONLY be in the foregrip. there is no room inside the body for a fuse in either setup.

[Nik12]

There you have it. You might not even have a fuse.

[fishbone]

thanks swatt and nik you guys have been helpful