Quote:
Originally Posted by six4
i went to an op-for game to switch out a loaner motor,,,and then it started popping fuses. at that point i realized that it was beyond my capabilities to repair and i left it in the hands of a gun tech. apparently "jasper" from op-for says it was my selector plate not dropping into the right place because of worn shims that was causing the draw. the shims werent to bad,,but enough to cause the "bottleneck". i will be testing/picking up the rifle on saturday the 14th. if all is well i will get a better description on what "jasper" did to fix my rifle and post that up in the aeg solutions section for anyone else who may have this problem along the way. for now im calling this problem solved and would like to thank everyone for the time and ideas.
|
*** SOLVED ***
so as it turns out,,the motor was bad and attributed to the electrical draw,but it was also the "beveled" shims that werent allowing the selector plate to drop into into proper position. after "jasper" did the re-shim, bridged the selector plate contacts, and swapped motors it is performing flawlessly. puked out an easy 3,000 rds on saturday's game without hardly a misfeed just make sure. this problem is now solved
July 15th, 2007, 17:24
