A&K masada

[Nateman332]

So.. I got some time lately to start putting my a&k masada back together after replacing the wiring and after attempting to put in the selector switch I snapped the selector plate in two...:banghead: so I obviously need a replacement. Would a normal m4/m16 selector plate work? maybe with some modification? if not, where can I buy the right one?

ps, I've searched for hours for the answer and can't find anything on google...

[waylander]

I actually bought a used masada which was missing the selector switch on one side. No luck finding it anywhere so I contacted A&K directly, they sent me to Evike as their NA distributor.

[Nateman332]

Originally Posted by waylander

I actually bought a used masada which was missing the selector switch on one side. No luck finding it anywhere so I contacted A&K directly, they sent me to Evike as their NA distributor.

Well airsoft depot has the selector switch, but I don't think even evike has the selector plate.

Sent from my Z933 using Tapatalk

[cetane]

My Masada is in pieces at the moment, but I don't remember there being much difference to a standard m4/16 plate. Looking at airsoftdepot the drop in Masada gearbox, the plate looks very similar. I'd try a m4 plate and mod if needed

[badrelko]

When I had my A&K I replaced the entire gearbox with a standard m4 one everything worked including the selector plate except obvs the nozzle

Sent from my Nexus 6P using Tapatalk

[Nateman332]

great! thanks everyone! I'm going to order one then and try it out

[Nateman332]

in regards to the selector plate, this has everything I did: http://www.bingoairsoftworks.com/upd...ne-conversion/