Working on a new project...

[Rage 01]

I am starting a new project and am looking for a few simple answers before I get started.

Are barrel nut threads the same on all AEG's?

Are barrel nut threads the same on all PTW's?

Does anyone happen to know what the thread sizes are for the AEG's and the PTW's?

I am constructing a new barrel nut and shroud combo.

Thankx.

[ThunderCactus]

no
no
G&P and PTW use the real steel nut sizing

And if you're planning on using standard ISO thread tolerances, your product likely won't fit most or some or a good chunk of airsoft guns since the quality control is so bad. Ran into that issue with my thread converters and barrel extensions, all my stuff was 6H but didn't fit a third of the time.

[Rage 01]

Originally Posted by ThunderCactus

no
no
G&P and PTW use the real steel nut sizing

And if you're planning on using standard ISO thread tolerances, your product likely won't fit most or some or a good chunk of airsoft guns since the quality control is so bad. Ran into that issue with my thread converters and barrel extensions, all my stuff was 6H but didn't fit a third of the time.

I have all ready ran into that problem my self. Any idea on the nut sizes?

Thankx.

[ThunderCactus]

real steel/G&P/PTW I believe was 1.25"x18

[Rage 01]

Thank you sir...

That helps a lot.