Plaged Glock 17... Help?

[randas]

Originally Posted by WhatTheWho

Maybe you could obtain close-ups of the hammer assembly? A better look at where this part may have broken off from might be good. (I'm guessing it'f from part 83, the hammer sear.

Yup, I think I found where its from- part 83

I cant figure out how to get the hammer arrembly apart.. do you have to push out that pin? (Part 86) Because I cant get it out...

[randas]

[QUOTE=randas]

Originally Posted by WhatTheWho

Maybe you could obtain close-ups of the hammer assembly? A better look at where this part may have broken off from might be good. (I'm guessing it'f from part 83, the hammer sear.

Yup, I think I found where its from- part 83

I cant figure out how to get the hammer arrembly apart.. do you have to push out that pin? (Part 86) Because I cant get it out...

[ILLusion]

That part would definitely be the cause of your sear problems.


Pop out the rear pin (part #86) and the hammer assembly should mostly come out.

Be careful of part 81 and spring 82 because those will tend to fly into oblivion once free of the frame. Do it in a bag or something.

Some other springs may fly loose at this time: spring 64 and 68.
You may also need to completely remove the trigger group in order to have easier access to the hammer assembly.

Pin 59 needs to be removed, as does screw 50 and the takedown lever #51 to release the trigger assembly. It'll be much easier to work with once you have all that out.

[randas]

Is there anything special you have to do to get out the pin (part 86) ?
Because no matter how hard I push it wont come out!

[MadMax]

You need a 1/16" punch and a mallet for some Glocks

[randas]

Thanks MadMax, all it needed was a little force!

Ok so I got it all apart... and it looks like it's form part 78...

[ILLusion]

If you need to purchase a replacement, PM me.

[randas]

Thanks, PMd!