|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
March 12th, 2013, 20:28
|
#16 |
|
Also on a side note the old batch of KJW charging handles were known issues for breaking at the front guide hole. Soooo if you file down the top front face section of the guide rod block on the bolt itself it save the charging handle. You don't need much just a slight slant on it is fine, all your trying to do is make it so that whe the bolt slams forward its not slamming against the end of the charging handle as after repeated use it will break.
|
|
|
|
|
March 12th, 2013, 21:52
|
#17 |
|
Alright thanks guys, I found a local retailer where I can get the V2 bolt for $39.99 with everything you said daishi. I hope the cradle upgrades are compatible with the new bolt. @Brian McIlmoyle, yeah the pictures doesn't show it justice. I clean it every game, it looks like rust from the pictures though ; )
__________________
Bolt Action Level 2 Certified Last edited by Olisharpeye; March 13th, 2013 at 15:07.. |
|
|
|
|
March 12th, 2013, 22:17
|
#18 |
|
The velocity reducer is compatible with the V2, but you have to use the V2's valve O-Ring because it is thinner than the cradle's O-ring, this has been known to provide much lower FPS.
Edit: Airsoftparts.ca does have 2 new charging handles from an aftermarket company: http://www.airsoftparts.ca/store2/in...oducts_id=2488 http://www.airsoftparts.ca/store2/in...oducts_id=2489 |
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
