glock 26c issue...

[Cheeseduck]

srry for posting this here, but i can't post in doctor's corner for some reason.(could a moderator move it thr for me?)

i have a brand new glock 26c...it recently has had issues with the slide not going all the way forward after a shot which causes it to stop shooting and i have to push it forwards myself for it to shoot again. it does this in both semi and full auto. it chambers the next bb just fine, it just doesn't seem to want to go back to its standard position without a little push. the mags are full of gas and there is no leak. i have lubed everything and cleaned it and still no change...any help or suggestions would b much appreciated.

i think it could possibly be a spring problem but if it is i don't know how to fix it and would prefer not to tinker until some1 can tell me how to do it or if thats even the problem.

[pusangani]

are your shots becoming progressively weaker too?

[Cheeseduck]

nope...they stay strong the whole mag and it blows back fully...so it's not like it's only getting half way back and then not getting enuf pull forward from the spring

[pusangani]

yeh sounds like the recoil spring dude, might need to get it replaced

[Cheeseduck]

damn...is thr any possible way to fix it even if temporarily??? i have a CQB game in 2 days and can't order one by then ahaha

[pusangani]

i dunno, see if anyone coming to that game has a replacement spring, its not hard to switch out, also if anyone has the same gun as u maybe they can bring it n u can swap it out to test

[Cheeseduck]

gah lol...kk thx for ur help pusangani. i'm still open to other ideas people as well as any options for the spring.

[pusangani]

the thing is, you don't know for sure if its the spring, i once thought it was spring in an old m93r i had and i went and stretched it out, lol turned out to be the blowback chamber was leaking!

[Cheeseduck]

no worries anymore guys...i finally fixed it...thr was a piece that i forgot to lube near the back of the slide and i noticed it was catching...it's no longer doing that. the piece that was catching wasn't going back to where it should and it was pulling opposite the spring which resulted in a standstill..

[pusangani]

sweet, good for u man and good luck at ur game

[Cheeseduck]

thx much buddy