TM hi-capa mags ejects when fired

[harsui]

Hi Folks,

I had a problem on my TM hi-capa that I recently purchased. Please give me some advise.

Here's the problem:
1. When i pulled the trigger, the mags ejects by itself.
2. I used propane tank and drop some silicon before i used it.

Please give me so expertise advise about this.

Thank you very much,
Harsui

[ILLusion]

Check your mag catch to make sure it's not worn down. Also make sure it's completely retracted to ensure full mag seating.

[Shinjin_MC]

make sure that the grip is properly seated with the frame as well
if it isnt, the recoil might jar the mag enough to make it drop

[harsui]

Thank you brethren,
When, i put the mag it sits there perfectly. I tried even to pull it down but it wont go. But when i fired it, thats the time it goes out.

Question Please?
Where is is mag catch located?
yap, i pushed it hard to sit properly to the snapper already.
I retracted the slides back and forth also.
This gun is only 4 days for me.

Anyway, I'll do that double checking when i get home.

Thank you very much for your well concerned comments.
Harsui

[Lakonian]

Check your MC's spring. Perhaps it's damaged. Also, like ILLusion said, check the edge of your MC. It may need replaced entirely.

This is by far, the weirdest Hicapa problem I have heard of.

[harsui]

thank you guys!!

[mateba]

i have the same problem. I just shoot with two hands

[Styrak]

Haha. This problem sounds kind of funny, more than anything.

[White_knight]

are you a left handed shooter, maybe your accidentally squeezing the mag release when squeezing the trigger (hey it could happen).