!!M4 Fuse Problems!!

[zero177]

i just bought a aeg M4A1 and i keep blowing the fuses which are 15 Amps. Some times the motor wont turn and when it will the fuse will blow in a few seconds. I am considering putting a 20 Amp fuse in but i dont want to risk blowing the gun when it has blown many of the perscribed 15 amp fuses. Should i continue and put the fuse in or is there another solution ?

[six4]

Originally Posted by zero177

i just bought a aeg M4A1 and i keep blowing the fuses which are 15 Amps. Some times the motor wont turn and when it will the fuse will blow in a few seconds. I am considering putting a 20 Amp fuse in but i dont want to risk blowing the gun when it has blown many of the perscribed 15 amp fuses. Should i continue and put the fuse in or is there another solution ?

is it new/used? and from what source did you get the rifle from? just wondering if you were sol d arifle with a bad motor thats causing your fuse problem

[Hectic]

if its new return it if not i would think someting in the gear box is stuck or sticking causing the motor to work too hard blowing the fuse instead of stripping or breaking gears
not a gun doc just my 2 cents

[CDN_Stalker]

Go for the 20A, you won't damage anything. Often times upgraded guns might need a higher amperage fuse than the stock 15A one. Usually it's because the mechbox isn't shimmed quite right.

[DYORD]

maybe it's low batt... or you should change your battery to a higher voltage. Sometimes it happens on a low batt and pressing the trigger for more than 2 secs.

[F34N0R]

remove the fuse. that's it. As long as you don't exceed 20A

[CDN_Stalker]

Originally Posted by *ATF*Feanor

remove the fuse. that's it. As long as you don't exceed 20A

Pretty much what I do on my AEGs, and often times wiring mods require space that a fuse holder won't fit into.