|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
May 26th, 2007, 20:07 | #1 |
Full Auto- MOST OF THE TIME in Semi auto...
I recently purchased two NEW CA MP5's from A&A. The problem I am having is that when the fire selector switch is in the semi-auto mode...it fires bursts of full auto ??? I have the MP5 A2 & A3 and both have the exact same problem!!! I am only using one & it seems to be getting worse the more I use it !!! Any suggestions ???? Oh yeah, the trigger when pulled fast will fire a single shot...sometimes !!
? selector plate ? trigger internals? |
|
May 27th, 2007, 09:01 | #2 |
possible cause.. excess shimming on the bottom part of the sector gear.. or... the cut of lever broke..
also... if you lose the small spring of the selector plate.
__________________
MORE FPS :banghead: |
|
May 27th, 2007, 09:38 | #3 |
How are you pulling the trigger on that gun in semi. Becuase I noticed that with my UTG MP5 it likes to make burst/full auto if i hold it in the half pull posistion while in semi auto. I also have a feeling it may be due to your battery. When I switched to a 7.2V the problem stopped but when I was using a 8.4 it was happening a lot
__________________
YANHCHAN'S AIRSMITHING: AEG repair/Tune up/Upgrades V2/V3 mechboxes, rewiring/reconnecting. Ask not what your country can do for you; ask what you can do for your country ~John F. Kennedy |
|
May 27th, 2007, 10:59 | #4 |
The mechbox has not been opened or touched! I'm using a 9.6v battery but why would this cause it to misfire? My systema mechbox does not do this !!!!
|
|
May 28th, 2007, 01:57 | #5 |
Defective selector plates!!!!
I purchased new CA MP5 selector plates from XT in Winnipeg & installed myself!
Misfiring in semi-auto has is now gone! Installed a Hurricane 120 upgrade kit! I'm using a 11.1 v Lipo battery from my RC planes & it ROCKS!!!! Please delete this thread! |
|
|
Bookmarks |
Thread Tools | |
|
|