hfc m92 fmv problem

[noldevin]

Recently my trigger has stopped springing back forward. Ok, no problem, I opened it up and re aligned the spring so it pushes the trigger forward. But now when I test it, i load the clip, cock it, and fire one shot, then the following trigger pulls just click the hammer forward and nothing happens. If i pull the slide back and push the little gas release valve pusher back up, I can get one more shot out of it before I have to do that again.
Is there some sort of spring that is supposed to reset that thing that I may have lost? Or is something else connected improperly? I tried numerous types of lever springs but none fit it so that it would be pushed back into place. Any help would be appreciated, thanks. :salute:

[stokes]

Did you take out the right grip? Because there is a small V shaped spring there that sits right behind the grip panel. That maybe missing or is installed incorrectly.

[noldevin]

I took both grips off, that must be the problem then. Does anyone have the instruction diagrams or a picture of this? Because I cant tell where it would go.

[stokes]

www.freewebs.com/jnande4176 go there. It will tell you how to properly install the spring. When the page opens up just press on the second picture (Your right hand side) it will load into a page that will help.

[noldevin]

Thanks for the link, but that spring is installed correctly. The trigger bar functions normally, its the part in the picture linked below that is causing the problem.

http://sdsource.ahl2mod.net/images/m92.jpg

I replaced the trigger spring through this part yet it still doesnt engage the gas release.