programmable MOSFETS wiring question

[Jimski]

Hey there,
I just onticed that programmable Mosfets have 4 wires output instead of 3. (usually 2 red 2 black)
What do you plug where ? I only have 3 cables sticking out of my mosfeted gun...

[Ron-E]

What MOSFET are you trying to install?

[Jimski]

it looks like that

[lurkingknight]

that's a burst controller.. not a mosfet. If you aren't interrupting the trigger wiring onto a separate circuit, it's not a mosfet unit. This unit still sends full voltage through your contacts.


To make it work you just put it in line with your wiring.. plug your gun in one end and battery into the other.

[ThunderCactus]

one wire goes to one side of the trigger
another (black) wire goes to the motor
final red wire goes to the OTHER side of the trigger and continues on to the motor

[lurkingknight]

http://www.spartanimports.com/MANUAL...sBurstUnit.pdf

it's not a mosfet.

[Jimski]

Originally Posted by lurkingknight

that's a burst controller.. not a mosfet. If you aren't interrupting the trigger wiring onto a separate circuit, it's not a mosfet unit. This unit still sends full voltage through your contacts.


To make it work you just put it in line with your wiring.. plug your gun in one end and battery into the other.

oh ok thank you !