|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
December 31st, 2011, 18:06
|
#1 |
|
removing WE air nozzle
Can anyone explain how to remove the black plastic floating air nozzle from the WE bolt?
im talking about this thing 
__________________
Never draw the sword without due reason And you'll never have to lay it down without honor  
|
|
|
|
December 31st, 2011, 18:17
|
#2 |
|
There is a pin about half way down the bolt carrier... punch that out and on the left side at the front of the bolt carrier is a plastic retainerplate.. pop that out... and lastly you need to take off the mock gas rod at the top of the bolt carrier and then remove the plastic retainer block under it. it should slide out after that. These can be removed or replaced in any order as well.
__________________
|
|
|
|
|
December 31st, 2011, 18:28
|
#3 |
|
__________________
|
|
|
|
|
December 31st, 2011, 19:19
|
#4 |
|
|
awsome thanks for the help. are plastic nozzles only available? im looking to upgrade mine with something and so far ive only found stock ones.
__________________
Never draw the sword without due reason And you'll never have to lay it down without honor
|
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
