|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
November 29th, 2010, 16:09 | #1 |
Problem with my tornado grenade.
I dont know if i'm in the good section since it aint a gun, but anyway, here is my problem:
I bought a used tornado grenade off someone, and when i came to test it, i filled it with gas, putted BBs in it, and when i removed the pin and threw it, nothing happened. It took at least 10-15 seconds before the grenade blew, and it didnt blow a lot. Is it because i didnt put enough gas? I know there is a technique to reduce explosion timing, but is the default explosion timing THAT MUCH long? And also, what is the instructions for the maintenance? |
|
November 29th, 2010, 16:10 | #2 |
Privateer Airsoft
|
Sounds like you didn't gas it up enough. I have to put a TON of gas into mine before I get a reliable timer.
__________________
I change primaries like other people change socks. |
November 29th, 2010, 16:39 | #3 |
I disassembled it, cleaned it, and i'll try it again tonight. Lets hope it works this time!
|
|
November 29th, 2010, 16:57 | #4 |
a.k.a. Egria
|
Also make sure that your propane tank isn't empty.
__________________
PURVEYOR OF FINE PARACORD PRODUCTS www.beaconconceptsco.com Click Here For ASC Thread Team GHOSTS - G86 |
November 29th, 2010, 16:57 | #5 |
Are you letting it sit for a few minutes after filling? Filling it makes it cold for a little while, which affects the timer. However even right after a fill it should "explode" somewhat.
|
|
November 29th, 2010, 17:13 | #6 |
Captain Sunshine
|
temperature affects it as well. were you testing it outdoors or indoors?
|
November 29th, 2010, 17:16 | #7 |
I was testing the grenade indoor, and i let it sit a 2-3 minutes. The propane tank was brand new, and it wasnt cold, it maybe was because it wasnt filling it enough, i filled it for a 6-7 seconds and after that propane was spilling off tje valve.. I'll try it again tonight.
|
|
November 29th, 2010, 17:18 | #8 |
8=======D
|
Lubrication.. do you have Grenade oil?
without lubrication the delay is unpredictable and long.. you need to lube the grenade with every reset for best results. Also make certain you give it a full gas charge.. the valve will back blast when it is full
__________________
Brian McIlmoyle TTAC3 Director CAPS Range Officer Toronto Downtown Age Verifier OPERATION WOODSMAN If the tongue could cut as the sword does, the dead would be infinite |
November 29th, 2010, 17:21 | #9 |
a.k.a. Palucol
|
Does it leak after being gassed?
|
November 29th, 2010, 17:26 | #10 |
make sure you have the end cap on with the center peice so theres no hole in the middle.
|
|
|
Bookmarks |
Thread Tools | |
|
|