Upgrade my PTW clone ecu

[etiny]

hi guy,

this ecu will be in stock on doubletaptactical.ca very soon..

[w1lp33]

Just my two cents: Be VERY careful installing this... My ribbon cable got a little pinched, and the whole thing died. And the way its constructed, you can't unplug the ribbon cable to replace it with a new one, so I basically bricked a $150 mosfet. Jackassery on my part for fucking up? Yes. Kind of shitey design that I couldn't just replace the ribbon cable? Also yes. Gonna get one from Fight Club Custom, the ribbon cable just plugs in at the end, so if I ruin everything again, I'm just replacing a cable, instead of the whole thing...

[rustysniper]

what isn't mentioned here is that current CTW models are NOT compatible with Systema and Systema aftermarket replacement electronics. Earlier versions were......so heads up to all current CTW owners (MX2 etc)

This mini board says it is compatible with Celcius but I would be skeptical as Systema OEM boards as well as Airsoft Surgeon are NOT

[skullz]

rusty, are they not compatible because of the trigger length mentioned here?
http://www.ptwairsoft.com/user-progr...-ecu-368-p.asp

all im guessing you need to do is replace trigger for a shorter one

if not, can you please explain as im looking to swap my power unit on my mx2

[mcguyver]

Originally Posted by skullz

rusty, are they not compatible because of the trigger length mentioned here?
http://www.ptwairsoft.com/user-progr...-ecu-368-p.asp

all im guessing you need to do is replace trigger for a shorter one

if not, can you please explain as im looking to swap my power unit on my mx2

So, you would ned a Gen 3 (2007) trigger? I'm sure there are tons of them around. I used to throw them out I had so many. But, maybe other guys did the same.

[rustysniper]

Has nothing to do with the trigger. X Max electronics were clones of the PTW but for some reason Celcius tried to make some changes centred around the rear switch device which affected the ECU and trigger for the MX2.
Other then the motor...if you want to go to PTW eketronics you need to swap out the 3 switch boards.....